Mosquito Magnet MM3300 Use and Care Manual download pdf (Page 4)

Assembly Instructions

Trap Assembly:

Place base upside down on a flat surface, unfold U-

shaped support leg until it locks in place.

Place trap power head onto pole. Press down firmly

with two hands to secure.

Assembled trap should have the front of power head/

trumpet placed farthest from the wheels in the same

direction as base U-shaped legs.

Turn base and leg assembly right-side-up and place

support pole into cavity on base.

The battery is not fully charged at the factory; charge

the battery before the first use. Under proper usage,

one charge lasts all season. See page 6 for further

details.

Step 1

Step 2

Step 3

Set-Up

Trap Placement

1. Determine the direction of the prevailing wind.

Check local weather patterns if you are unsure.

2. Stand in the center of the area you are trying to protect

and look toward the prevailing wind.

3. Proper placement of the trap will be 30 – 40 feet in front

of you, within 5-6 feet of ground cover (i.e. bushes,

flowerbeds, tree line, marshbed). Ensure that trap is not

directly against any blockades such as buildings, fences, etc.

4. It is recommended that the trap be placed in the shade.

5. Do not place trap directly above a water source

(sprinklers, hose, etc.).

6. Trap must be placed on level ground to avoid tipping

or uneven propane distribution.

7. For optimal trap placement in your yard, refer to the

instructional CD-ROM included with your trap; or, go to

www.mosquitomagnet.com to build your own yard

diagram for correct trap placement.

Charging Instructions

1. Remove cover panel from rear of Power Head Unit

(panel snaps off). Press the battery latch & pull out of

the trap to disconnect. Remove the battery by pulling up

on the bottom and rotating the battery out of position.

2. The Battery Charger is not rated for Outdoor use. The

battery must be charged indoors.

3. Plug the Battery Charger into a suitable indoor outlet.

4. Connect the re-chargeable battery to the battery

charger.

5. The LED on the Battery Charger will indicate Red when

the battery is charging, when the battery is fully charged

the LED will indicate Green. The typical charge time is

less than two hours.

6. The battery charger is automatic, it will shut down to a

safe maintenance charge current when the battery is

fully charged. It will not over charge the battery. For

maximum life, do not leave the battery on the charger

for extended periods.

7. When the battery is fully charged, disconnect the

battery from the battery charger and return it in the

Mosquito Magnet Executive.

8. Insert and connect the re-chargeable battery.

9. Replace the cover panel on the rear of Power Head Unit.

NOTE: Make sure cover panel is replaced; trap is not

weatherproof with cover panel removed.

Bug Bag Installation:

To insert Bug Bag, first engage front/open section then gently

push the back end down into place.Step 4Step 4

Step 4

Remove Back Panel

Insert & Connect Battery

O O

1440-650_Exec_US_2011B 9/27/11 9:11 AM Page 7

1 2 3 4 5 6 7 8 9 ... 17 18

Comments to this Manuals

No comments

Mosquito Magnet MM3300 Use and Care Manual Page 4

Comments to this Manuals

Related products and manuals for Garden tools Mosquito Magnet MM3300