Mosquito Magnet Liberty Specifications download pdf (Page 3)

Safety Instructions

• Maintain adequate clearances of 20”–24” around air

openings into the combustion chamber, clearances from

combustible material, provisions for accessibility and for

combustion and ventilating air supply. Keep the Liberty

Plus area clear and free from combustible materials,

gasoline, and other flammable vapors and liquids. The

appliance is not to be used in locations where flammable

vapor or explosive dust is likely to exist.

• Do not obstruct the flow of combustion and ventilation air.

• Keep the ventilating openings of the cylinder enclosure

free and clear from debris.

• Clean the Liberty Plus with a water damp cloth, if necessary.

• A maximum of a 20 lb. LP-Gas cylinder shall be used.

• The LP-Gas cylinder must be provided with a shut-off valve

terminating in an LP-Gas supply cylinder valve outlet

specified for Connection No. 510 in the Standard for

Compressed Gas Cylinder Valve Outlet and Inlet

Connections, ANSI/CGA-V-1-1977.

• The LP-Gas cylinder supply system must be arranged for

vapor withdrawal and the cylinder must include a collar to

protect the cylinder valve.

• The LP-Gas cylinder used shall be constructed and marked

in accordance with the specifications for LP-Gas cylinders

of the U.S. Department of Transportation (DOT) or The

National Standard of Canada CAN/CSA-B339.

• The Liberty Plus shall be used outdoors only in a well

ventilated space and shall not be used in a building, garage,

or any other enclosed area.

• The LP-Gas cylinder must be disconnected and removed

from the appliance, if the appliance is stored indoors.

• LP-Gas cylinders must be stored outdoors in a well-

ventilated area out of reach of children.

• Disconnected cylinders must have threaded valve plugs

tightly installed and must not be stored in a building, garage,

or any other enclosed area.

Note: Some or all of the following required safety

instructions for propane powered devices may

apply to your Liberty Plus. Allow trap to cool for 5

minutes before re-starting.

Warning: Improper installation, adjustment,

alteration, service or maintenance can cause injury

or property damage. Read the installation, operating

and maintenance instructions thoroughly before

installing or servicing the Liberty Plus.

Caution:The gas pressure regulator provided with this

appliance must be used. This regulator is set for an outlet

pressure of 11.0 in. Water Column. The minimum inlet gas

supply pressure is 11.0 in. Water Column from regulator.

• This unit is not intended to be installed in or on recreational

vehicles and/or boats.

• The gas supply must be turned off at the LP-Gas supply

cylinder when this appliance is not in use.

• The installation must conform with local codes or, in the

absence of local codes, with the National Fuel Gas Code,

ANSI Z223. 1-1998 for US and with the CAN1-B149 for Canada.

• To test for a gas leak, place soapy water around the

connector, regulator, and gas hose assembly. If bubbles

appear, there is a gas leak.

• Inspect the hose before each use of the unit. If it is evident there

is excessive abrasion or wear, or the hose is cut, it must be

replaced prior to the unit being put into operation. The

replacement hose shall be that specified by the manufacturer.

• The Liberty Plus is equipped with an internal spark ignition device.

Failure to follow starting procedure will result in the trap not starting.

• Installation and repair should be done by a qualified service

person (find service centers on www.mosquitomagnet.com).

The heater should be inspected before use and at least

annually by a qualified service person. More frequent

cleaning may be required as necessary. It is imperative

that the control compartment, burners, and circulating

air passageways of the heater be kept clean.

Children and adults should be alerted to

the hazards of high surface temperatures

and should stay away to avoid burns or

clothing ignition.

Young children should be carefully

supervised when they are in the

area of the heater. Keep out of

reach of children.

Clothing or other flammable materials

should not be hung from the heater,

or placed on or near the heater.

• The pressure regulator and hose assembly supplied with this

appliance must be used for connection to the LP-Gas

cylinder. Replacement pressure regulators and hose

assemblies must be specified by the manufacturer.

• Avoid improper use of extension cords. Keep connections

away from moisture and avoid damage to the cord.

• If the supply cord is damaged, it must be replaced by the

manufacturer or its service agent or a similarly qualified

person in order to avoid hazard.

Please contact Customer Care

if you have any questions at:

1-800-953-5737

or visit www.mosquitomagnet.com

Please read and follow all safety

instructions and warnings.

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Mosquito Magnet Liberty Specifications Page 3

Comments to this Manuals

Related products and manuals for Garden tools Mosquito Magnet Liberty