Trap Assembly:
6
For accessories and additional info go to: www.mosquitomagnet.com
Charging your Mosquito Magnet
®
Liberty Plus
1 . Remove cover panel from rear of Head Unit (panel snaps off).
2 . Insert and connect re-chargeable battery.
3 . Insert Charging Adapter into rear of Head Unit.
Allow to charge for 24 hours at the beginning of each
season. You will not need to charge again until next season.
Replace cover panel when completed (panel snaps into place).
N O T E : Unit must be charged indoors, trap is not
weatherproof with cover panel removed.
Attractant Installation:
See Mosquito Magnet
®
attractant label for installation,
use, storage and disposal instructions.
Trap Placement
1 . Determine the direction of the prevailing wind.
Check local weather patterns if you are unsure
2 . Stand in the center of the area you are trying to protect
and look toward the prevailing wind.
3. Proper placement of the Liberty Plus will be 30 – 40 feet
in front of you, within 5-6 feet of ground cover (i.e., bushes,
flowerbeds, tree line, marshbed). Ensure that trap is not
directly against any blockades such as buildings, fences, etc.
4 . It is recommended that the trap be placed in the shade.
5 . Do not place trap directly above a water source
(sprinklers, hose, etc.).
7 . Trap must be placed on level ground to avoid tipping
or uneven propane distribution.
8 . For more information, refer to trap placement CD-ROM
included with your Liberty Plus.
Installation
5
American Biophysics 1-877-699-8727
Assembly Instructions
Step 1
Step 2
Step 3
Net locks into front of compartment
Step 4
See Attractant Package for details.
H o r n
Remove Back Panel
Insert & Connect Battery
Plug Charger Into Battery Charging Powerhead
For optimal trap placement
in your yard, refer to trap
placement CD-ROM included
with your Liberty Plus.
Step 5
Charge Liberty Plus for 24 hours before use.
See pg. 6 for further details.
NOTE: You will not need to charge it again until the
following season.
Net Installation:
Lift clear plastic lid and lock plastic holding bracket of net into
front of compartment. Close plastic lid when finished.
N o t e : Fabric loops hook over plastic posts allowing net
to expand to it highest capacity.
Place base upside down on a flat surface, unfold U-shaped
support leg until it locks in place.
Insert the Plume Tube into horn and turn until Tube locks
into place.
Place Liberty Plus power head onto pole. Press down firmly
with two hands to secure.
Assembled trap should have the front of power head
in the same direction as base U-shaped legs.
Turn base and leg assembly right-side-up and place support
pole into cavity on base.
(35 pages)
(18 pages)
(18 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals